Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Version
11
Page 35 of 117
Status
Issued
Last Editor
Jeerh, Manpreet
Date
March 2020
Document
Name
WIMAG GENERAL HANDBOOK
Doc. No.
667/HB/47200/000
Copyright
©
Siemens Mobility Limited 2012. All Rights Reserved.
5.2 Status LEDs Indications
The WIMAG Loop Detector Replacement Card detector provides a visual indication
of output in the form of LEDs, these will be visible in all ambient light conditions:
There are two modes for the 4x2 LED array;
Mode 1;
•
4x Detector Output State
– Red : when activated these LED will be ‘ON’ when
there mapped detector is in detect state.
•
4x Detector Fault State
– Red : when activated these LED will be ‘ON’ when the
mapped detector is reporting a fault or the Access Point reports lost
communication to that detector.
Mode 2;
Status indication provided by top left LED only. This LED shows the current state of
the firmware. 50/50 ratio flash indicates normal operation. 80(on)/20(off) flash
indicates that a major fault is present and the firmware has entered shutdown mode.
In addition there is a power status LED;
•
1 x POE Power State
– Red : This in normally ‘OFF’ when the supply circuitry is
considered good. Will illuminate when there is a supply failure e.g. supply drops
below 12V.
