Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Version
11
Page 31 of 117
Status
Issued
Last Editor
Jeerh, Manpreet
Date
March 2020
Document
Name
WIMAG GENERAL HANDBOOK
Doc. No.
667/HB/47200/000
Copyright
©
Siemens Mobility Limited 2012. All Rights Reserved.
4.5.2
Front Panel Description
Figure 20 : Standard Interface : Front Panel
4.5.3
Status LEDs Indications
The WIMAG Standard Interface Card detector provides a visual indication of output
in the form of LEDs, these will be visible in all ambient light conditions:
•
1x Fault State
– Red : will only be ‘ON’ when any one of the mapped detectors is
in fault state or the Access Point reports lost communication to that detector.
•
1x System Run
– Red : This in normally ‘ON’ when the card status is considered
good.
•
1 x SW Run
– Red : This in normally ‘ON’ when the card software is running.
