Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Version
11
Page 38 of 117
Status
Issued
Last Editor
Jeerh, Manpreet
Date
March 2020
Document
Name
WIMAG GENERAL HANDBOOK
Doc. No.
667/HB/47200/000
Copyright
©
Siemens Mobility Limited 2012. All Rights Reserved.
The following aspects should be considered when referring to the above design
documents:
1. All references to
Contact Closure Cards (CCC)
should be ignored and cross
referenced to
Siemens WiMag standard interface card
2. All references to Access Point Controller Card (APCC) and AccessBox should be
ignored. These are not supplied by Siemens.
3.
Access Points
will be installed at a height of 5m and therefore the range to the
sensors will be 30m
1
maximum or 25m for deep install versions.
4.
Repeaters
are to be mounted at a minimum preferable height of 6m. However, if
this is not available then they are to be mounted at a minimum height of 5m.
Standard sensor range is 45m
2
or 40m deep install variants.
5. The
Power supply
to access points will always be via a 48V PoE switch, which
will be assembled as part of the
WiMag Communications Rack
or the WiMag
Loop Detector Replacement Card, when fitted.
6. The section relating to the
data backhaul
is to be ignored as this is covered by
the standard controller implementation.
7.
Sensor locations
are defined by standard VA, SCOOT and MOVA loop location
requirements. All three standards do allow for an element of deviation from ideal
locations.
8. WiMag is not for use in SDE/SA applications.
9.
The reader is to refer to ‘System design Guide’ for IPS and WiMag
667/HB/47200/001.
6.2 Design Guidelines for Access Points
The reader is now referred t
o ‘System Design Guide’ for IPS and WiMag
(667/HB/47200/001).
1
Assumes VSN240-F-2 or VSN240-F-GR
2
As above
