Sharp EL-9650, Operation Manual, Page: 233 / 373

223
SLIDE SHOW FUNCTIONS
2. Creating an Original Slide Show
The calculator provides a function which allows you to create your own slide show
screens and register them.
• The number of screens which you can store may vary depending on the amount of
free memory. (It is possible to register as many screens as the memory capacity
allows. However, if you use up most of the memory for the slide show, this may affect
other calculations.)
• A title can be put on the original slide show. (Only one title can be put on the slide
show.)
• The flowchart for creating your original slide show is shown below.
Enter the slide show creation mode. :
C ®
Put a title on the slide show. : Input a title.
®
Register screens. : After creating an original slide show, press
Ï
to store the original slide show.
• The original slide show has no specific end mark. (When another slide show is
created following the original slide show, the previous data is cleared and updated by
the new slide show.)
• That is, the built-in graph for “Y = AX + B” is completed on the 8th screen.
(At this time, use of
≥
is invalid but use of
≤
is valid.)
* The number of screens may vary depending on the selected equation.
That is, not all equations are composed of 8 screens.
* To exit the slide show screen, press
Ï œ
to return to the standard function calculation
screen viewed immediately before starting the slide show.
• When
≥
is pressed sequentially, the slide show
screen for “Y = AX + B” is stopped on the screen
shown to the right.
EL-9650-(10)En (221-228) 8/3/00, 4:56 PM 223