HandKey II Manual
57
Format
Description
Format Detail
MagStripe
formats
9
MS09=MAG1
ABA Track 2
Input ID len 25
Output min len 1
Output max len 25
Do trim leading zeroes
Oriented right, no offset
10
MS10=MAG2
ABA Track 2
Input ID len 25
Output min len 1
Output max len 25
Do trim leading zeroes
Oriented right, no offset
11
MS11=MAG3 Octal 7
ABA Track 2
Input ID len 7
Output min len 1
Output max len 25
Do trim leading zeroes
Oriented right, no offset
MS11=MAG3 Octal 7 is the format used
for FingerKeys with a ProxIF reader.
Set Input Formats, the first sub-option under Set
Credential Formats, controls which card formats the
reader will accept at either an internal or external
card reader. You can choose up to five Wiegand or
two Magstripe card formats. You must choose either
Wiegand or Magstripe formats; you can’t use both.
Most companies use only one format.
The possible formats are shown under Available Card
Formats on page 54; the reader is initially set to accept
input in formats 7, 6, 4, 2, and 1; you only need to use
this option if you use some format other than one of
these or if you want to prevent some of these formats.
Enter formats in descending order; if you set more
than one input format, the reader sorts them in
descending order from the largest bit format to the
smallest, with None having the lowest value. For
example, if the reader is set to:
Input Format 1: WC08
Input Format 2: WC07
Input Format 3: WC06
Input Format 4: WC05
Input Format 5: WC04
and you change Format 1 to None, the formats adjust
to:
Input Format 1: WC08
Input Format 2: WC07
Input Format 3: WC06
Input Format 4: WC05
Input Format 5: NONE
Press ENTER to set the card formats
the reader will accept. You’ll see:
Press ENTER to set Input Format 1.
Press # (Next) to go to Input Format
2. When you press ENTER to change
any input format, you see something
like:
Line 1 shows the card format that is
currently selected. Line 3 shows the
format that will be chosen if you press
# (Yes). Press * (No) to cycle to the
next available format; press # (Yes) to
choose the format.
After you set Input Format 1, follow
the same procedure for Input Formats
2-5.
SET INPUT FORMATS
* BACK # NEXT
SET INPUT FORMAT1
* BACK # NEXT
WC07=07=37BIT:19BIT ID
SET TO NONE
* NO # YES
Setting Input
Formats
