Clicking a camera number in the Camera setting table causes the video from the selected camera to appear in the Preview area.
Set the encoding format.
Setting options: MPEG4 and MPEG4+
These tabs are used to configure detailed condition settings.
Configure the motion sensor feature that senses any motion in the target.
The sensing sensitivity can be set in nine levels (Level 1 to 9).
Higher the sensitivity level, lower the sensing sensitivity.
When [User defined] is selected:
The [Add] button becomes selectable, allowing you to define the sensing area as desired.
In the preview area, click in the grid cell where you want to enable sensing.
Each time you click, the color of the selected grid cell toggles between red and blue to indicate that sensing is enable or disabled, respectively.
Click
to discard all sensing area settings.
When [Full region] is selected:
The whole screen is set as the sensing area.
The whole preview area is enclosed with a red border to indicate that full-region sensing is enabled.
You cannot set the contents of the [Network Camera] and [PTZ] tabs via the network.
In the Preview area, portions where any motion is sensed under the configured conditions will be indicated by blue rectangles.
These rectangles are shown based on the sensing sensitivity and sensing area settings currently stored in the system.
If you have changed any of these sensing conditions, click the [Exit] setting button to save the settings you have configured.
Reset
167/182
ページ
2008/10/27