Preliminary
STATIC MEMORY CONTROLLER
S3C2451X RISC MICROPROCESSOR
5-10
Preliminary product information describe products that are in development,
for which full characterization data and associated errata are not yet available.
Specifications and information herein are subject to change without notice.
SYNCHRONOUS WRITE/ SYNCHRONOUS BURST WRITE
Figure 5-11 shows an example synchronous write operation. In this example the signal SMADDRVALID provides
a one-cycle pulse. This behavior is enabled by setting the SyncWriteDev bit in the SMBCRx register. You must
also set the AddrValidWriteEn bit for synchronous write.
The signal PnWE is only active for one cycle. This is active at the start of the transfer unless it is delayed using
the control bits WSTWEN to delay it.
Synchronous burst writes are supported by the SMC. There is no write buffer so you must delay the AHB transfer
to enable the data to be output onto the SMDATA bus. You can control the write in the same way as reads using
the bits AddrValidWriteEn, BurstLenWrite, SyncEnWrite, and BMWrite contained in the Bank Control Register,
SMCRx.
SMCLK
ADDR
DATA(OUT)
Synchronous Write
nCS
nWE
A
D(A)
SMAVD
WSTWR=3
WSTWEN=2
Figure 5-11. Synchronous Two Wait State Write
