Safegate Group safedock, User Manual

Page: 196 / 348

SAFEDOCK®

Safegate Group
Manual Date: 6 February 2015
Chapter: 4A Stand Configuration Utility Version: 2.7
Page 10 of 26
4.2.16 Docking Procedure

Use rolling arrows in downgrade: If checked, the system will allow the rolling
arrows to be displayed even in downgrade mode; by default the system is
preventing this type of signal in downgrade mode.

Use engine verification: If checked, the system will perform engine verification on
the approaching aircraft, unless specifically disabled for a particular aircraft.

Standstill time: The time (in seconds) that the aircraft must be at a standstill
before the docking is considered complete.

Ok message time: The time (in seconds) that the OK message will be displayed.

Too far message time: The time (in seconds) that the TOO FAR message will be
displayed.

Stop short detection distance: Maximum distance from the stop-position at which
the system may consider the docking completed if the aircraft is at a standstill.
Must be > 0 to enable the function.

Stop short detection time: The time (in seconds) that the aircraft must be at a
standstill before the docking is considered finished if the aircraft stops before the
stop-position. Must be > 0 to enable the function. Stop short message time: The
time (in seconds) that the
STOP SHORT message will be displayed.

ID-Fail message time: The time (in seconds) that the ID FAIL message will be
displayed. During this time, it is possible to restart the docking without engine
identification check, using the
“ID-override” button.