Safegate Group safedock, User Manual

Page: 167 / 348

SAFEDOCK®

Safegate Group
Manual Date: 6 February 2015
Chapter: 4 MAINTENANCE Version: 2.7
Page 33 of 52
(a) Switch OFF and isolate the power supply.
(b) To gain entry to the Laser Scanning Unit, undo the cabinet lock and open the
hinged door.
(c) Disconnect the Laser Range Finder electrically by pulling out the green connector
from the terminal block.
(d) Remove the two socket head cap screws, which secure the Laser Range Finder
to the bracket.
(e) Lift the Laser Range Finder clear of the bracket.
6.4.2 Inspection
Carry out an internal inspection of the Laser Scanning Unit assembly as detailed in §
6.1.2 Inspection, items (b) to (e).
6.4.3 Assembly
(a) Locate the new Laser Range Finder and secure to the bracket with the two socket
head cap screws.
(b)
Connect the Laser Range Finder’s electrical leads to the terminal block.
(c) Close the cabinet door and secure using the locks.
6.4.4 Testing
(a) Reconnect the power supply to the Laser Scanning Unit and switch ON.
(e) Verify the centreline definition according to Chapter 4A Stand Configuration Utility.
(f) If the centreline definition points are not correct, the system must be set up again.
This means: defining and verifying the centrelines, setting calibration check points
and making a new backup of the Stand configuration file. Please refer to Chapter
4A Stand Configuration Utility.
(b) Perform a walk-test procedure.
6.4.5 Reset Laser Statistics
Note : This operation is to be performed whenever a laser unit is replaced.
(a) From the Operator Panel, select Test .
FIGURE 4.39
– OP TEST
(b) From the Test menu, press the right arrow for the next page and select
Statistics .
FIGURE 4.40
– OP STATS
(c) From the Statistics menu, select Reset laser and then Confirm to reset the laser
time.
FIGURE 4.41
– OP RESET LASER
Test Gate
Sign
Safedock SYSTEM
READY
Open
Stand Park
On Start
Dock
Walk
Test OP
Test Light
Sens Temp
Sens View
Log
Program version
SOS 1.0.0
Mirr
Pos Laser
Test Scan
Test Disp
Test Mirr
Test
Set
IP Re-
start
Program version
SOS 1.0.0
Com
info Cal
Test Stati
stics
Reset
Laser Back
STATISTICS
Laser
Time Ok
Dock ID
Fails Total
Dock
Back
Confirm laser
Reset on : <YYYY-MM-DD>
time reset
Accep
t