Safegate Group safedock, User Manual

Page: 65 / 348

SAFEDOCK®

Safegate Group
Manual Date: 6 February 2015
Chapter: 2A Operator Panel Softkey Setup Version: 2.7
Page 7 of 8
4. EXTRA OPERATOR PANEL (OPTION)
The Operator Panel can be connected to an extra Operator Panel, to control Safedock
from another place.
The extra Operator Panel must also be set with a unique Com1 address. For
example, if Operator Panel1 Com1 address is 1 (default) then Operator Panel2 Com1
address is to be set to 2.
Note : The system only accepts input via the first Operator Panel (Com1 address 1).
Outputs on all connected Operator Panels are always in the same state.
Connect and set and extra Operator Panel as follows:
Connect an Operator Panel (Operator Panel1) to
an extra Operator Panel (Operator Panel2)
Safedock
Note
: It is important to rewire the Emergency
Stop loop, as both Operator Panel Emergency
Stop buttons must be in the same loop.
For maintenance procedures, it is
recommended to use the Operator Panel1
maintenance outlet with a laptop, and
therefore a connection between the Operator
Panel1 and Operator Panel2 maintenance
outlets is not advised or necessary.
For more information regarding termination of
wiring, see Chap 5 DRAWINGS.
OP 1 OP 2
PWR -
PWR +
COM -
COM +
EM
PWR -
PWR +
COM -
COM +
EM
Set the Operator Panel2 COM1 address in menu software
From Operator Panel2, change the comm. address (default set as 1) to 2 as follows:
(a) Disconnect the power.
(b) Press and hold down the
CANCEL key whilst re-connecting power,
to access the set-up menu.
(c) Press Set up Func .
(d) Press Com1 addr .
(e) Press the + key (upper right) to change current address (from default, 1) to 2 .
(f) Press CANCEL .
(g) Press CANCEL again.
(h) Confirm to change the setting.
(i) Press
ENTER to return the Operator Panel to operation.