Safegate Group safedock, User Manual

Page: 199 / 348

SAFEDOCK®

Safegate Group
Manual Date: 6 February 2015
Chapter: 4A Stand Configuration Utility Version: 2.7
Page 13 of 26
3.
Press the “Save Calibration” button.
4. Verify that the silhouette of the apron corresponds to the imaginary line
between the placed markers. Only a single point will be displayed for each
marker.
Note: This method cannot be used if Apron Scan is activated.
4.4.3 Feature Buttons
Apart
from the button “Start Scan” and “Use Calibration” there are several buttons for
this feature that can be used:

Home
– can be used to send the mirrors to their home position. Used when
adjusting the mirrors on their axis.

Distance to home
– used to measure the distance from the mirrors current
position to their home position.

Set centre point
– click this, then click in the image to acquire a new image
centred on the clicked point.
4.5 AUTO CALIBRATION
Auto calibration or “automatic calibration check” is a safety measure used to make
sure that the hardware is OK or that the system has not been moved out of its original
position since being commissioned.
FIGURE 4A.7 - SMT
– AUTO CALIBRATION FEATURE
The procedure to setup the auto calibration is following:
1. Enter fitting values for the Hor , Ver , Size Hor and S ize Ver settings so that the
system looks in the desired direction.
2. Acquire a new image
by using “Start Scan”.