Figure 4.26
NTP configuration
1.
NTP Status –
shows if NTP is enabled or disabled (command line –
system ntp
status
);
2.
NTP enable –
allows enabling or disabling NTP. By default this feature is disabled
(command line –
system ntp
[enable|disable]
);
3.
NTP server IP address –
allows to specify NTP server IP address (command line –
system ntp server
<IP address>
);
4.
NTP time zone (-
12..12) – allows to specify UTC (Coordinated Universal Time) offset
(command line –
system ntp timezone
<UTC offset>
);
5.
By pressing
„Execute configuration”
changes made to the corresponding section
apply only for the local side CFIP PhoeniX. If
„Rollback on”
is selected, configuration
will be reverted in case erroneous configuration changes are applied;
6.
Writes to configuration file all the changes made on the whole page (command line
–
cfg write
);
4.
Restarts CFIP PhoeniX you are connected to (command line –
system reset
).
7.
4.4.5
Upgrade Software
Figure 4.27
Upgrade software
1.
Choose file
– allows choosing location of software upgrade file (e.g.
cfipidu165.elf.ezip) stored on your hard disk. Software upgrade file must have
*.elf.ezip extension.
4.4.6
Service information
Figure 4.28
Service information
1.
Open full system information page / Download system information
– allows to
open/save full system information page. Links on the top of the page allow you to
save full system information page and alarm log in separate txt files on your hard
disk drive;
(!)
Note that after restarting the CFIP will use only those settings, which are written to
the configuration script. Other settings will be set to default values
.
CFIP PhoeniX Series TDM/IP Split Mount System Technical Description and Configuration Guide
•
Rev. 1.13
•
© SAF Tehnika JSC 2015
57