4.11
SNMP v1/v2 configuration
The SNMP v1/v2 configuration pages provide configuration of SNMP communities, host and trap
addresses. SAF NMS system will work only when SNMP is properly configured.
Explanation of customization fields:
4.11.1
SNMP community configuration
Figure 4.57
SNMP community configuration
1.
Read -
Specifies the SNMP v1/v2 community name of the agent to enable
parameters to be read (not configured) (command line –
snmp community read
<communityname>
and
snmp2 community read
<communityname>
);
2.
Write –
specifies the community name of the agent to enable parameters to be
written (configured) (command line –
snmp community write
<communityname>
and
snmp2 community write
<communityname>
);
3.
Trap –
specifies SNMP v1/v2 trap community name for trap authentication in
monitoring applications (command line –
snmp community trap
<communityname>
and
snmp2 community trap
<communityname>
);
4.
SNMP trap host list –
shows the list of IP addreses of the management terminal with
the installed Trap Manager software, based on SNMP v1/v2 platform. The CFIP
PhoeniX management controller sends SNMP traps to the Trap Manager with IP
address specified here. The SNMP Trap Manager is a PC with installed SNMP trap
management software. The default Trap Manager IP address is
255.255.255.255
meaning that no trap packets are sent by the management controller
;
5.
Allows to add or delete SNMP v1/v2 trap host IP addresses from the list (command
line –
snmp trap
<IP addresses of trap receivers>
and
snmp2 trap
<IP addresses of
trap receivers>
);
6.
By pressing
„Execute configuration”
changes made to the corresponding section
apply only for the local side CFIP PhoeniX. If
„Rollback on”
is selected, configuration
will be reverted in case erroneous configuration changes are applied.
4.11.2
SNMP Allowed Hosts Configuration
CFIP PhoeniX Series TDM/IP Split Mount System Technical Description and Configuration Guide
•
Rev. 1.13
•
© SAF Tehnika JSC 2015
79
