prompt command “
system reset
”
Resetting with command prompt command
“
system reset cold
”
Restarts modem and CPU of the management controller. Resets
all management counters.
2.3
Web Interface
This section describes operation of Web interface.
2.3.1
10/100/1000Base-T Ports
10/100/1000Base-T port is used to connect CFIP PhoeniX to a PC or Ethernet network for Web,
SNMP and Telnet management.
(!)
The length of 10/100/1000Base-T Port cable should not exceed 100m.
2.3.2
Ethernet Management Connection Configuration
Before proceeding with initial link setup in Web GUI, you must adjust IPv4 settings of your LAN
adapter to 192.168.205.0 subnet. IP address should be other than default low/high side IP addresses
(192.168.205.10/192.168.205.11).
Figure 2.3
Internet Protocol Version 4 (TCP/IPv4) Properties
After applying these settings you are ready to connect to Web GUI or establish Telnet
connection.
2.3.3
Connecting to Web Interface
It is recommended to use the following web-browsers (and all later versions):
CFIP PhoeniX Series TDM/IP Split Mount System Technical Description and Configuration Guide
•
Rev. 1.13
•
© SAF Tehnika JSC 2015
21