Figure 2.11
STEP 2. Defining IP address, mask, default gateway and remote IP address
The third screen of the wizard is devoted to the modem and radio configuration and requires
specifying utilized bandwidth (from 3.5 to 56 MHz), modulation type (4QAM, 16QAM, 32QAM,
64QAM, 128QAM or 256QAM), E1 channel port numbers, Tx power (range depends on modulation
chosen) and Tx frequency; besides, the modem and radio data status is being shown. These
configuration parameters will determine overall link capacity.
Figure 2.12
STEP 3. Defining modem bandwidth and modulation
The final screen allows checking the selected settings and applying them. The optional settings
are as follows:
–
Clear cfg file before the new settings will take place
– resetting or keeping all the other
parameters, not mentioned here, after configuration execution
–
Set local machine time
– uses the time of your laptop
–
Write this configuration into cfg file
– configuration is automatically written in
configuration file
If
„Rollback on”
is selected, configuration will be reverted in case erroneous configuration changes are
applied
CFIP PhoeniX Series TDM/IP Split Mount System Technical Description and Configuration Guide
•
Rev. 1.13
•
© SAF Tehnika JSC 2015
27
