Ruckus Wireless ZoneSwitch 4124, User Manual

Page: 237 / 410

223
Command Line Interface
Layer-2 Interface Commands
switchport protected uplink
Specifies the port to isolate (protect) and an uplink interface. Disabled by default.
Command Mode: Interface Configuration
Syntax
[no] switchport protected uplink { ethernet <port id> | port-channel
<trunk id> }
Description
■
ethernet <port id>
- Sepcifies the ethernet port to be used as an uplink interface.
■
port-channel <trunk id>
- Sepcifies port channel to be used as an uplink interface.
■
no switchport protected uplink
- Disables port isolation.
Example
!Enables port isolation on port 4 and sets the uplink to port 20.
Switch(config)#
interface
GigabitEthernet 1/4
Switch(config-if)# switchport protected uplink Ethernet 1/20
Switch(config-if)#
!Enables port isolation on port 1 and sets the uplink to trunk 1.
Switch(config)# interface GigabitEthernet 1/1
Switch(config-if)# switchport protected uplink port-channel 1
Switch(config-if)#
!Disables port isolation on port 4.
Switch(config)# interface GigabitEthernet 1/1
Switch(config-if)#
no switchport protected
Switch(config-if)#