Ross Opengear UDC-8625A Series, User Manual, Page: 45 / 174

UDC-8625A Series User Manual (Iss. 11) Configuration • 3–5
Configuring the Video Outputs
The Output Setup menus in the Config tab enable you to specify the format for all the card
outputs, configure what to output, and adjust the timing of all outputs.
For More Information on...
• input status alarms, refer to the section “ Input Status Menus ” on page 9-32.
• enabling alarms, refer to the section “ Alarm Enables Menus ” on page 9-34.
• input status fields in the Signal tab, refer to the section “ Signal Tab ” on page 9-2.
To configure your video outputs on the card
1. From the Device View in DashBoard, select the Config tab.
2. Select the Video tab located at the bottom of the Config tab.
Config Tab — Output Setup Area
3. From the Output Format menu, select the video format. The output must be compatible
with the selected reference.
4. Configure each output by selecting an option from its Output menu:
• Processed — The output is processed, with Wings and key inserted (if selected).
• Clean Feed 1 — The output is processed. The keyer and Wings are not included
with this output.
• Clean Feed 2 — The output is processed, with Wings inserted (if selected). The
keyer is not included with this output.
Note
— The Wings, Key Video, and Key Alpha sources must be the same format as
the output format. Refer to Table 9.4 on page 9-7 for a list of available formats.
Note
— The menus and parameters for Output 4 are not implemented when using
the 8322AR-065 rear module.