Ross Opengear UDC-8625A Series, User Manual, Page: 35 / 174

UDC-8625A Series User Manual (Iss. 11) Installation • 2–15
Audio Cabling Overview
This section provides audio cabling information for the UDC-8625A-A and UDC-8625A-B.
UDC-8625A-A Cabling
Both the 8320AR-053A and 8320AR-053B rear modules each provide eight unbalanced
connections for AES sources. Depending on the rear module type, you will have DIN connections
(8320AR-053A) or HD-BNC connections (8320AR-053B). Refer to the section “
UDC-8625A-A
Cabling ” on page 2-11 for cabling designations.
UDC-8625A-B Cabling
The 8320AR-052A rear module provides 3-pin audio terminal blocks with removable connectors.
Each connector has locations for the positive, negative, and grounded wires of a balanced AES
audio cable.
To wire the AES audio for the UDC-8625A-B
1. Insert an AES audio wire to the designated polarity slot on the connector of the rear
module. (
Figure 2.13 )
Figure 2.13 Connector Wiring for Rear Module Input Sockets
2.
Use a tweaker screwdriver to tighten the corresponding capture screw.
3.
Repeat steps 1 and 2 for each wire on each connector.
4.
Once the cables are wired to the connectors, install the connectors on the terminal blocks
for the rear module.