Ross Opengear UDC-8625A Series, User Manual, Page: 27 / 174

UDC-8625A Series User Manual (Iss. 11) Installation • 2–7
To install the card in an openGear frame
1.
When using the 8320AR-041 or 8322AR-065 rear module , install the card in an even
numbered slot (e.g. slot 2, 4, 6 etc.).
2.
When using a rear module other than the 8320AR-041 or 8322AR-065, install the card
in slot 2, 6, 10, 14, or 18.
3.
Hold the card by the edges and carefully align the card edges with the rails in the frame.
4.
Fully insert the card into the frame until the card is properly seated in the rear module.
Note
— The slot number is dependent on the slot combinations you installed the
rear module in. This allows adequate spacing to avoid damaging the card, the cards
installed in the neighboring slots, or both.