Ross Opengear UDC-8625A Series, User Manual, Page: 82 / 174

6–4 • Audio Configuration UDC-8625A Series User Manual (Iss. 11)
Configuring the AES Outputs
This section briefly summarizes how to configure the options in the AES Outputs tab when the
AES I/O Config is set to 0 in, 8 out or 4 in, 4 out.
For More Information on...
• the options available in the AES Outputs tab, refer to Table 9.18 on page 9-23.
To configure the AES outputs
1. From the Device View , select the AES Outputs tab.
AES Outputs Tab — AES IO Config Set to 4 in, 4 out
2. If required, select the sub-tab that includes the AES source you wish to configure.
3. To specify the channel source of an AES output:
• Use the associated Ch# Source Type and menu to select the source type that is used
for the AES output. Note that the parameter selected in this menu determines what
is available in the Ch# Source Sel menu.
• Use the associated Ch# Source Sel menu to specify a source.
4. To set the gain for a channel of an AES output, use the associated Ch # Gain slider to
select a value between -20dB and 20dB.
5. To set the delay for a channel of an AES source, use the associated Ch # Delay slider to
select a value between 0ms and 500ms.
6. Repeat steps 2.- 5. for each AES output you wish to configure.