Ross Opengear UDC-8625A Series, User Manual, Page: 156 / 174

12–2 • Appendix D. Cascade Feature UDC-8625A Series User Manual (Iss. 11)
Cabling for the Cascade Feature
This appendix assumes the following equipment is used:
• One OG3-FR series frame with an MFC-OG3-N Network Controller card
• Two UDC-8625A-B cards installed in the frame
• Two 8320AR-052A rear modules installed in the frame
In Figure 12.1 , the rear module depicted on the left is for the first UDC-8625A-B while the rear
module on the right is for the second UDC-8625A-B. Note that the slots that your rear modules
are installed in may differ than what is presented here. Ross Video does not supply the required
cables.
Cabling Overview
1. Connect an input video signals to SDI IN 2 (BNC 1) on the first UDC-8625A-B. For
simplicity, Figure 12.1 depicts only one SDI input, but you may require more. Refer to
the section “ UDC-8625A-B Cabling ” on page 2-12 for specific cabling designations.
Figure 12.1 Cabling for the Cascade feature
2. Connect SDI OUT 1 (BNC 5) on the first UDC-8625A-B to SDI IN 3 (BNC 2) on the
second UDC-8625A-B.
3. Connect the remainder of the input and output video signals to the rear modules as
required.
4. Connect the reference source for UDC-8625A-B cards.
For More Information on...
• additional connections for your card, refer to chapter “ Installation ” on page 2-1.
OG3-FR Series Frame
PS1
100-240V~47-63Hz 450W
CAUTION: RISK OF SHOCK
DO NOT OPEN
!
REF 1
LOOP
REF 2
LOOP
PS2
ETHERNET
100-240V~47-63Hz 450W
CAUTION
RISK OF SHOCK DO NOT OPEN
!
Reference Source
to REF 1 IN
Wings Source to SDI IN 2
From SDI OUT 1 To SDI IN 3