Ross Opengear UDC-8625A Series, User Manual, Page: 111 / 174

UDC-8625A Series User Manual (Iss. 11) Appendix A. DashBoard Menus • 9–7
Configuration Menus
This section briefly summarizes the sub-tabs available in the Config tab.
Video Tab
Table 9.4 summarizes the Video set up options available in DashBoard.
Table 9.4 Video Menu Items
Menu Title Item Parameters Description
Reference
Setup
Reference Input
Frame 1
The card uses the reference source
connected to the
REF 1 port on the
openGear frame
Frame 2
The card uses the reference source
connected to the
REF 2 port on the
openGear frame
Local
The card uses the external reference
source connected to the
REF IN port on
the rear module. You must also configure
JP7 on the card to enable or disable a
75ohm terminator on the external
reference input.
Output Setup
Output Format
a
480i 59.94
Selects the video format for the output
signal. Note that a change in video format
will not take effect until the reference is
compatible.
720p 59.94
1080i 59.94
1080i 59.94 LEVEL A
576i 50
720p 50
1080i 50
1080p 50 LEVEL A
Output #
b
Processed*
Specifies to output the processed signal
with the Wings and Key
Clean Feed 1
Specifies to output the processed signal.
The Key and the Wings are not applied on
this output.
Clean Feed 2
Specifies to output the processed signal
with the Wings. The Key is not applied on
this output.
External Wings
Selects the external video input being used
for the Key 1 - Wings to be passed through
to the output with minimal processing.
Ensure the input video format is the same
as the output video format and that the
signals are insync. Refer to the section
“
Appendix D. Cascade Feature ” on
page 12-1 for details on this feature.