Rohde & Schwarz R&S RTB2000, User Manual

Page: 213 / 609

Serial bus analysis
R&S
®
RTB2000
213 User Manual 1333.1611.02 ─ 11
Remote command:
BUS<b>:STATe
on page 464
Configuration
Opens or closes the dialog box with configuration settings of the selected bus.
The following chapters describe manual protocol configuration:
●
Chapter 13.5, "Parallel buses" , on page 276
●
Chapter 12.2.2, "SPI configuration" , on page 222
●
Chapter 12.3.2, "I²C configuration" , on page 231
●
Chapter 12.4.2, "UART configuration" , on page 238
●
Chapter 12.5.2, "CAN configuration" , on page 246
●
Chapter 12.6.2, "LIN configuration" , on page 260
Trigger
Opens the trigger setup for the selected protocol.
The following chapters describe protocol triggering:
●
Chapter 12.2.3, "SPI trigger" , on page 225
●
Chapter 12.3.3, "I²C trigger" , on page 232
●
Chapter 12.4.3, "UART trigger" , on page 241
●
Chapter 12.5.3, "CAN trigger" , on page 248
●
Chapter 12.6.3, "LIN trigger" , on page 262
Triggering on parallel buses is not possible.
Note: Selecting "Trigger" in the protocol menu automatically enables protocol decod-
ing.
Display Setup
Opens a menu to define display settings, e.g. data formats. Display settings are valid
for all protocol types.
See Chapter 12.1.2, "Displaying decode results" , on page 214.
Label List
Opens a menu to load and apply a list with symbolic names of addresses or identifiers.
Only available for CAN and LIN.
See Chapter 12.1.5, "Label list" , on page 218.
Bus Table
Opens a menu to define bus table settings for the decoded frames of the acquisition.
See Chapter 12.1.3, "Bus table: decode results" , on page 215.
Label
Opens a menu to define a label for the selected bus.
See Chapter 12.1.4, "Bus labels" , on page 217.
Basics of protocol analysis