Rohde & Schwarz EX-IQ-BOX, User Manual

Page: 373 / 418

Interfaces
R&S
®
EX-IQ-BOX
358 User Manual 1409.5570.32 ─ 05
Table 10-3: LAN connector > pinout
Pin Num-
ber Signal Description
1 TXP
2 TXN
3 RXP
4 Not used
5 Not used
6 RXN
7 Not used
8 Not used
10.3 Breakout Boards
The digital interface module R&S EX-IQ-BOX communicates with the aid of a breakout
board directly with the DUT. A variety of available breakout boards provide convenient
customization of digital signal formats, since they are all connected at the same interface
(user interface) of the R&S
EX-IQ-BOX. Thus with the R&S EX-IQ-BOX and the appro-
priate breakout board you can easily perform applications of user-defined or standardized
transmission protocols.
The following chapters provide information on the interfaces, connectors and pinouts of
the available breakout boards:
● ​
chapter 10.1, "User Interface of the R&S EX-IQ-BOX" , on page 355
–
​
chapter 10.3.1.1, "Breakout Board Single Ended 3585.7280.00" , on page 359
–
​
chapter 10.3.1.2, "Breakout Board Differential 3585.7296.00" , on page 361
–
​
chapter 10.3.1.3, "Breakout Board Cadence Palladium 090002-24x" ,
on page 364
● ​
chapter 10.3.3, "CPRI - Option R&S EXBOX-B85" , on page 367
10.3.1 User Defined
Various interchangeable breakout boards are available for adjusting customer specific
signal formats to the common R&S digital signal format.
A breakout board is connected directly to the user interface on the front panel of the
R&S
EX-IQ-BOX without using a cable. The pin assignment for each breakout board is
defined by the layout.
Two breakout boards for User Defined protocols are included in delivery of the R&S EX-
IQ-BOX:
●
single ended 090002-22x, type II, see
​
Breakout Board Single Ended 3585.7280.00
Breakout Boards