Rohde & Schwarz EX-IQ-BOX, User Manual

Page: 109 / 418

R&S EX-IQ-BOX Configuration
R&S
®
EX-IQ-BOX
94 User Manual 1409.5570.32 ─ 05
The setup of the new data may take up to 15 seconds, especially if you have changed
the logic type. During the configuration the analyzer indicates in the "Setup State" field
that the configuration is in progress. During configuration, you can not perform any set-
tings.
Fig. 6-27: ExBox Status > configuring box ...
It also indicates if the configuration is completed.
Fig. 6-28: ExBox Status > box is configured
6.2.2.4 I/Q Data Transmission
Signal transmission starts by pressing the "SEND TO" hotkey.
Send to
Start signal transmission. The direction path of signal transmissioin is determined in the
"Select Type" field in
​
chapter 6.2.2.3, "Dialogs" , on page 92.
Remote command:
​
[:
​
SOURce]:
​
RECeiver:
​
SENDto
​
on page 260
​
SOURce:
​
TRANsmitter:
​
SENDto
​
on page 260
6.2.3 R&S Protocol Tester
The parameters are set by using the R&S DigIConf software.
Some R&S instruments, as e.g. the R&S CMW500 may have installed the configuration
software directly. Check in the operating manual to see if your instrument supports this
mode of operation. How to operate R&S
DigIConf refer to
​
chapter 6.1, "R&S DigIConf
Configuration Software" , on page 53. The parameters are described in
​
chapter 7, "Pro-
tocol Settings" , on page 95.
Configuration via R&S Instruments