Rohde & Schwarz EX-IQ-BOX, User Manual

Page: 371 / 418

Interfaces
R&S
®
EX-IQ-BOX
356 User Manual 1409.5570.32 ─ 05
Information on Z-DOK-Adapter Board Connector
The described pin assignment applies to applications with the R&S EX-IQ-BOX controlled
by R&S DigIConf. If an R&S Instrument controls the R&S EX-IQ-BOX directly, the pinout
varies. For information on the differences, refer to
​
chapter 10.1.3, "Advanced pinout with
R&S DigIConf" , on page 357.
Find detailed information on the PC Board Footprint, the Housing and the Block Diagram
Mating Face Configuration in the customer drawing C-6367557, attached to the operating
manual.
Table 10-1: Pinout Z-DOK-Adapter Board Connector (User Interface)
Signal Name Pin Dir Description
BO_TYPE0 A2 I breakout board identification or
EEPROM
BO_TYPE1 A1 I
BO_SENS Z3, X3, Y3, W3 breakout board sense
UI_I_N/P0 ... UI_I_N/P17 F1/F2 ... C9/C10 I/O I data (real part)
UI_Q_N/P0 ... UI_Q_N/P17 C13/C14 ... D23/D24 I/O Q data (imaginary part)
UI_VALID_N/P F13/F14 I/O indicates valid data blocks
Note: This signal must be active in
receiver mode.
D_CLK_UIN_N/P F25/F26 I interface clock input.
Note: This clock signal is required as
a reference for PLL. Therefore, it
must be active continuously.
D_CLK_UOUT_N/P A13/A14 O interface clock output
UI_GP_N/P0 ... UI_GP_N/P5
[1] F11/F12 ... A25/26 I/O additional protocol dependent con-
trol / signaling. If not needed the sig-
nal can be unconnected.
UI_AUXIO_N/P0 ... UI_AUXIO_N/P3 A23/A24 ... D11/D12 I/O additional auxiliary signals
TX_N_A/TX_P_A A27/A28 O high speed serial transmitter output.
These signals are used by standar-
dized protocols.
TX_N_B/TX_P_B F27/F28 O
TX_N_C/TX_P_C D2/D1 O
RX_N_A/RX_P_A D28/D27 I high speed serial receiver input.
These signals are used by standar-
dized protocols.
RX_N_B/RX_P_B C28/C27 I
RX_N_C/RX_P_C C26/C25 I
[1]
GP0 ... GP5 correspond to the General Purpose signals 0...5 as they are named in
other R&S instruments and R&S devices.
The N/P notation applies to differential interface standards (LVDS). For single ended
standards (e.g. LVTTL) only the P signals are used.
User Interface of the R&S EX-IQ-BOX