Remote Control Basics
R&S
®
EX-IQ-BOX
221
User Manual 1409.5570.32 ─ 05
For further program operation refer to the online help of the program.
Setting up a Telnet Connection
This chapter provides an example on how to establish a remote control connection over
telnet protocol and a simple sockets-based program example that can be further devel-
oped.
To control the software, only a telnet program is required. The telnet program is part of
every operating system.
1. To establish a Telnet connection with R&S DigIConf, start the telnet program and
enter the socket address.
The socket address is a combination of the IP address or the host name of the R&S
DigIConf and the number of the port configured for remote-control via telnet.
Tip:
R&S DigIConf uses the port number 5026 for remote connection via Telnet.
The connection to the instrument is set up and remote-control commands can be
sent.
Remote Control Interfaces and Protocols
Summary of Contents for EX-IQ-BOX
Page 147: ...Protocol Settings R S EX IQ BOX 132 User Manual 1409 5570 32 05 CPRI...
Page 391: ......
