Getting Started
R&S
®
EX-IQ-BOX
34
User Manual 1409.5570.32 ─ 05
4.3.2.6
POWER - Power supply
The R&S
EX-IQ-BOX is supplied with an external power supply unit and a separate power
cable, see
chapter 4.5, "Connecting the R&S EX-IQ-BOX"
The Power LED indicates the different operating states of the device, depending on the
state of the external voltages.
●
OFF
: the external power supply unit is not connected ("Power Off state").
●
Yellow
: the main power of the device is
on
but the USB power is
off (Standby
state)
.
●
Green
: the main power and the USB power are on. The device is ready for operation.
4.4 Installing R&S DigIConf
This section describes how to install the software R&S
DigIConf (
Dig
ital
I
nterface
Con
figurator), the tool for controlling the protocol settings of the R&S
EX-IQ-BOX. It also
encloses the hardware and software requirements which have to be met for installation.
Software and Hardware Requirements
It is recommended that your PC fulfills the following minimum requirements:
Component
Minimum requirement
Operating system
Windows 2000 SP4 / XP SP1 (32 bit), Windows 7
CPU
Pentium 4, 1 GHz or higher
RAM
256 MB
Hard disk
100 MByte free space
Monitor
XGA monitor (1024 x 768)
Interfaces
USB 2.0
Tip:
USB 1.1 is also supported, but due to the lower transmission speed, it is
recommended to operate with USB 2.0.
For some Rohde & Schwarz instruments, e.g. the R&S CMW500, it is possible to install
R&S
DigIConf directly on the instrument. The operating manual of the instrument states
if the instrument supports this mode of operation. The installation on the instrument is the
same as on the PC, see below.
Installing R&S DigIConf
Summary of Contents for EX-IQ-BOX
Page 147: ...Protocol Settings R S EX IQ BOX 132 User Manual 1409 5570 32 05 CPRI...
Page 391: ......
