Rohde & Schwarz EX-IQ-BOX, User Manual

Page: 381 / 418

Interfaces
R&S
®
EX-IQ-BOX
366 User Manual 1409.5570.32 ─ 05
Pin
Num-
ber Signal Name Comment Pin
Num-
ber Signal Name Comment
X2.17 UI_Q_P0 Q component X2.51 GND
X2.18 UI_Q_P1 X2.52 GND
X2.19 UI_Q_P2 X2.53 GND
X2.20 UI_Q_P3 X2.54 GND
X2.21 UI_Q_P4 X2.55 GND
X2.22 UI_Q_P5 X2.56 GND
X2.23 UI_Q_P6 X2.57 GND
X2.24 UI_Q_P7 X2.58 GND
X2.25 UI_Q_P8 X2.59 GND
X2.26 UI_Q_P9 X2.60 GND
X2.27 UI_Q_P10 X2.61 GND
X2.28 UI_Q_P11 X2.62 GND
X2.29 UI_Q_P12 X2.63 GND
X2.30 UI_Q_P13 X2.64 GND
X2.31 UI_Q_P14 X2.65 GND
X2.32 UI_Q_P15 X2.66 n.c.
X2.33 D_CLK_UOUT_P interface clock output X2.67 D_CLK_UIN_P interface clock input
X2.34 D_CLK_UOUT_N X2.68 UI_VALID_P indicates valid data
blocks
Information on the pinouts of the connectors - Cadence Palladium breakout board
Find the pin assignments of this breakout board in the appendix of the operating manual,
drawing number 090101-331-25AEZ00. The drawing covers the user interface, connec-
tor X1 and the SCSI connector X2.
10.3.2 Other Customer Breakout Boards
Other connected Customer Breakout Boards always run in "User defined" mode. This
mode will only work properly if the beakout board is recognized as a "customer board".
In order for the breakout board to be recognized as a "Customer Breakout Board", the
following conditions must be met:
The signals BO_TYPE0, BO_TYPE1 and BOB_SENSE
must be set to LOW .
Breakout Boards