9. OPERATION
IMR01N12-E7
114
9.7 Control Area Transfer
The control area transfer can be made by Event input (optional) or Communication (optional) other than the key
operation. For details of transfer by communication, refer to the
Communication Instruction Manual
(IMR01N13-E
)
.
*
* Refer to
Communication Instruction Manual (IMR01N14-E
)
for PROFIBUS,
Communication Instruction Manual (IMR01N15-E
)
for DeviceNet, and
Communication Instruction Manual
(IMR01N21-E
)
for CC-Link.
Control area transfer by Front key operation
Press the UP key or the DOWN key to change the desired memory area number used for this control. Press the
SET key to store the new setting.
SET
MODE
OUT1
A/M
R/L
R/S
AREA
PV1
PV2 MAN
REM
AT
PV2
MAN REM AT
SV
or
The Memory area number stored at last is taken as Control area.
The Memory area number (control area) can be changed at either RUN or STOP.
For the SV setting & Monitor mode, refer to
5. SV SETTING & MONITOR MODE (P. 30)
.
Control area transfer by Event input
Memory area (control area) transfer by the Event input is possible with the
Event input logic selection
(P. 73)
of the Engineering mode. The table below shows the Event input status and selected memory numbers for
Control area transfer.
Event
input
Memory area number
1 2 3 4 5 6 7 8 9 10
11
12
13
14
15
16
DI 1
DI 2
DI 3
DI 4
: Contact open
: Contact closed
To store a new Memory area number as the Control area, close the DI for Memory area set.
[Display example]
