ST-SP Pag.
42 Rev 02 05/13
UK
E
This label warns about the danger due to the presence of elements under
voltage in proximity of the area in which the machine is positioned.
F
This label warks about the obligation to read the manual for the installation
G
Warning to the sharp parts durino condenser cleaning
3.5 Work Area and Position of the Operator
The machine functions automatically requesting the intervention of the operator corresponding to the control and command
software only to manually start and stop and for functioning programming. The operator's work area therefore exclusively
corresponds to the control panel on the machine.
3.6Noise and Vibration Indications
3.6.1 Noise
B
LOCKSYSTEM
ST-SP were designed and manufactured to reduce the noise emitted during normal functioning to a minimum.
The level of mass acoustic pressure A generated by B
LOCKSYSTEM
ST-SP
and measured, following the criteria set by the norms in
force, during functioning is less than 70 dB (A).
3.6.2 Vibrations
In use conditions in compliance with the instructions supplied by the manufacturer in this handbook, the vibrations were not such
to create dangerous situations.
The operator however, if vibrations occur, should immediately stop the machine and signal the phenomenon to the
manufacturer’s support service.
3.7 Proper and Improper Use of the Machine
The machine was designed and built solely for permanent industrial and commercial refrigeration. The ST Blocksystem must be
installed on an horizontal surface; the SP Blocksystem on a vertical one.
The
MACHINE
can only use the refrigerant gas it has been designed for (typically R404A). Alternatively the manufacturer can supply
models able to use other refrigerant gases (e.g. R134a). Check the machine tag to identify the correct refrigerant gas to use.
The machine was designed and built to be operated in areas without the risk of explosion, the machine itself however does not
create this type of risk. The machine must be adequately protected from the elements.
It is good practice to place powder fire extinguishers near the machine. To reduce the risk of fire it is necessary to keep plastic
parts, oils, solvents, paper and rags away from the machine.
Use of the machine other than that stated can cause harm to people or damage the actual machine itself, and is deemed as
improper use for which the Manufacturer cannot be held responsible.
WARNING:
in the case of different use it is essential to previously contact the Technical Department of the
Manufacturer.
3.8 General Warnings and Behavioural Norms
To avoid any risky conditions to people or damage to the machine, we recommend you scrupulously follow the general warnings
and behavioural norms reported here.
DANGER:
the manufacturer declines all responsibility for any damage to property and/or persons deriving from
improper interventions conducted by unqualified, untrained or unauthorised staff.
The operators responsible for machine management must be adequately trained to use it at its best and without risk and
must operate in a comfortable environment that guarantees the best safety and hygiene conditions possible.
