70
Laser Scanners
RF627, RF627Smart [Revision 2.1.2] 20.09.2021
rise edge
fall edge
first, constr
last, constr
"Index"
0...256
The segment index used in the "Mode" = "by index".
"Min len", mm
0,01...1000
The minimum segment length used in modes
"Mode" = "first, constr." and “Mode” = “last, constr.”.
"Max len", mm
0,01...1000
The maximum segment length used in modes
"Mode" = "first, constr." and “Mode” = “last, constr.”.
"Angle", deg
-90...90
The angle of inclination of the segment relative to the
horizontal axis. It is used in modes "Mode" = "first,
constr." and “Mode” = “last, constr.”
"Angle tolerance",
deg
0...89
The tolerance (in both directions) of the angle of
inclination of the segment relative to the horizontal
axis. It is used in modes "Mode" = "first, constr."
and “Mode” = “last, constr.”
Outputs:
“seg”
SDT_SEGMENT The segment corresponding to the block
parameters.
“line approximation” - line approximation of profile points (in two areas).
original profile without
approximation
approximation of lower fragments
approximation of upper fragments
Outputs:
“line”
SDT_LINE
The line that approximates the points located in
areas.
“calculate filling” - calculating the total area of the profile deviation from the base input line.
