RF627, RF627Smart [Revision 2.1.2] 20.09.2021
Laser Scanners
121
#
Description
Screenshot
5
In the "Relative constraints"
section of element 1, add a
constraint of the "Angle" type.
6
Select the added constraint in
the "Relative constraints" list and
specify the target angle and
tolerance. When determining the
target angle, it is necessary to
roughly align the gray arrow with
the relative element. The
numerical value of the current
angle between the elements is
also shown. When specifying a
tolerance, the displayed sector
must include a relative element.
7
Reset the previous selection by
clicking in an empty area (which
does not contain any elements of
profile approximation).
Select segment 1 and then
immediately select segment 4 -
in this case, it will become a
relative element.
8
In the "Relative constraints"
section of element 1, add a
constraint of the "Distance" type.
9
Select the added constraint in
the "Relative constraints" list and
set the minimum and maximum
distance values.
