RF627, RF627Smart [Revision 2.1.2] 20.09.2021
Laser Scanners
19
15.2.2. Video mode
The
Video
mode provides viewing of the video stream from the CMOS sensor of
the scanner with overlapping of the detected profile on the image (in
Raw
mode).
Image transfer speed is determined by computer performance (average value is
about 15 frames/s).
The image is displayed on two screens. On a small screen, the yellow rectangle
shows the position of the viewing area.
Green color indicates the points of the uncalibrated profile selected by the scanner
from the image. When viewing the image in the calibrated profile mode, only the video
signal is displayed.
The area of additional display options contains a button for starting / pausing the
video stream, a button for editing defective pixels (
Edit pixels
), a button for saving a
screenshot (i.e. saving the full image from the scanner image sensor regardless of the
display scale), a slider for adjusting the gamma correction of the image, and a button for
resetting the gamma correction to its original value.
Gamma correction is applied only to the displayed frame in the web interface and is
intended to improve the visual visibility of low intensity areas.
The procedure for editing defective pixels is described in Annex 2.
16. Setting parameters
To configure the scanner settings, go to the required tab and make changes.
All the settings, except network settings, are applied immediately. In order for the
network settings to take effect, it is necessary to click the
Apply
button. All changes are
made in RAM and will be lost when you restart the scanner. If you want to save parameters,
write them to the nonvolatile memory of the scanner before restarting. Control buttons are
located in the upper right corner of the window (see par.
).
