Ricoh FAX880 MP, Operator'S Manual

Page: 65 / 261

Selecting Which Messages To Lock
1
Press the Function key and
6,2,2,2,2,6,3 using the ten keypad. then
press the Yes key.
SETTING? Y/j
PRINT LIST j
❐
At this time, you can print a user parameter
list, press the
j
key, then press the Start key.
2
Press the Yes key, then press the
k
key
until the settings for Switch 09 are dis-
played.
KPAD/Y/j k
SWITCH 09: 0000:0000
3
Change the setting of digit 7 by press-
ing 7 on the ten keypad. The effect is
shown in the table opposite.
KPAD/Y/j k
SWITCH 09: 1100:0000
4
To finish: Press the Yes key, then press
the Function key.
NOTE: If you wish, you can prevent unidentified senders from sending you
messages while Memory Lock is on (See page 69).
Programming the List of Special Senders for Memory Lock
A terminal sending an incoming message always identifies itself to your
terminal. The identification consists of an RTI or CSI. When you use Memory
Lock, you must program a list of these codes as Special Senders using
Function 71 (see page 73).
Digit 7
0: Only messages from Special Senders
are locked in memory.
1: All messages are locked in memory
except those from Special Senders.
LOCKING INCOMING MESSAGES
54