Rice Lake Legend 480-2A, Technical Manual

Page: 68 / 85

Status Messages 61
9.1.2 Using the XE EDP Command
The XE EDP command can be used to remotely query the 480 for the error conditions shown on the front panel.
The XE command returns two five digit numbers in the format:
xxxxx yyyyy
where
xxxxx
contains a decimal representation of any existing error conditions as described in Table 9-2.
If more than one error condition exists, the number returned is the sum of the values representing the error
conditions. For example, if the XE command returns the number 1040, this value represents the sum of an A/D
reference error (1024) and an A/D calibration checksum error (16).
The second number returned (
yyyyy
) uses the same bit assignments as shown in Table 9-2 to indicate whether the
test for the error condition was run. For example, the value
yyyyy
= 50815 represents the decimal equivalent of the
binary value 1100 0110 0111 1111. Using the bit assignments in Table 9-2, this value indicates all tests were run.
Table 9-2. Error Codes Returned on XE Command
9.2 Status Messages
Two EDP commands, P and ZZ, can be used to provide status about the indicator. These commands are described
in the following sections.
9.2.1 P EDP Command
The P EDP command returns the current displayed weight value, along with the units identifier. If the indicator is
in an underrange or overload condition, the weight value is replaced with
&&&&&&
(overload) or
::::::
(underrange).
9.2.2 ZZ EDP Command
The ZZ EDP command can be used to remotely query which annunciators are currently displayed on the indicator
front panel. The ZZ command returns the currently displayed weight and a decimal number representing the LED
annunciators currently lit. The format of the returned data is:
wwwwww uu zzz
where
wwwwww uu
is the current displayed weight and units, and
zzz
is the annunciator status value (see Table 9-3).
If more than one annunciator is lit, ZZZ is the sum of the values representing the active annunciators.
Error
Code Description Binary Value
1 EEPROM Error 0000 0000 0000 0001
2 Virgin EEPROM 0000 0000 0000 0010
4 Config Parameter Checksum 0000 0000 0000 0100
8 Load Cell Checksum 0000 0000 0000 1000
16 A/D Calibration Checksum 0000 0000 0001 0000
32 Print Formats Checksum 0000 0000 0010 0000
64 XA Internal RAM Error 0000 0000 0100 0000
128 External RAM Error 0000 0000 1000 0000
256 Reserved 0000 0001 0000 0000
512 ADC Physical Error 0000 0010 0000 0000
1024 ADC Reference 0000 0100 0000 0000
2048 Count Error 0000 1000 0000 0000
4096 Reserved 0001 0000 0000 0000
8192 Display Range 0010 0000 0000 0000
16384 ADC Range 0100 0000 0000 0000
32768 Gross Limit 1000 0000 0000 0000
0x10000 - 0x80000000 Reserved