Rice Lake Legend 480-2A, Technical Manual

Page: 14 / 85

Introduction 7
1.8.6 Preset Tare (Keyed Tare)
1. With the scale empty and display showing zero weight, press .
000000
is displayed with the focused
digit flashing.
2. Edit the value using the following method; or with the 480 PLUS , use the keypad. See Section 1.7 on page 4.
• Press or to select the digit.
• Press or to increment or decrement the value.
3. Press when the value is correct. The display will change to the Net mode and the
PT
LED lights to
show the preset tare was entered.
1.8.7 Display Tare
When a stored tare value is displayed, the gross and net LEDs will be off and the will be lit.
To display a stored tare:
1. Press .
2. Press to
AUDIT
.
3. Press to
TARE
and press .
4. Press repeatedly to return to weighing mode.
If there is no tare in the system,
0
will displayed and the Gross and Net LED will be off.
See Section 9.14 for more information pertaining to the regulatory mode of operation.
1.8.8 Print Ticket
1. Press to print either the gross or net format.
2. Wait for the LED to light.
3. Press to send data to the serial port.
If the LED is not lit and is pressed, the print action will take place only if the scale comes out of
motion within three seconds. If the scale stays in motion for over three seconds, the press is ignored.
1.8.9 Toggle Gross/Net Mode
1. Press to switch the display mode between gross and net. If a tare value has been entered or acquired,
the net value is the gross weight minus the tare.
Gross mode —
Gross/Brutto
LED is lit.
Net mode —
Net
LED is lit.
1.8.10 View Audit Trail
See Section 3.1 on page 22 for audit trail settings.
1. Press .
2. Press to
AUDIT
.
3. Press . The audit trail
CALIB
is displayed.
4. Press then or to
CNT
,
TIME
or
DATE
.
5. Press to view selected parameter.
6. Press twice to return to
CALIB
.
7. Press to the audit trail
CONFIG
and repeat steps 5 and 6 to view configuration number.
8. Press repeatedly to return to weighing mode.
TARE
TARE
MENU
PRINT
PRINT
PRINT
PRINT
GROSS
NET
B/N
MENU