Rice Lake Legend 480-2A, Technical Manual

Page: 16 / 85

Introduction 9
1.8.14 Display, Edit and Set Setpoint Value
See Section 8.0 on page 59 more information.
1. Press .
2. Press to AUDIT.
3. Press until display reads
SETPNT
.
4. Press and navigate across to desired setpoint number (1-8).
5. Press and navigate across to select
USER
.
6. Press and navigate across to select
VALUE
or
ENABLE
.
7. Press to view and edit the value.
• To edit Value, use the following method; or with the 480 PLUS , use the keypad. See Section 1.7 on page 4.
- Press or to select the digit.
- Press or to increment or decrement the value.
- Press when the value is correct.
• To edit
ENABLE
:
- Press or to select
On/Off
.
- Press when the value is correct.
8. Press repeatedly to return to weighing mode.
See Section 3.1.1 for the
SETPNT
menu layout.
1.8.15 View Firmware Version
1. Press .
2. Press .
AUDIT
is displayed.
3. Press until display reads
VERS
.
4. Press .
FIRMW
is displayed.
5. Press to view version.
6. Press repeatedly to return to weighing mode.
1.8.16 Enter User Password
1. Remove the setup switch access screw from the back of the enclosure. See Figure 2-1 on page 10.
2. Insert a non-conductive tool into the access hole and press the configuration switch. Indicator display
changes to show
CONFIG
.
3. Press or until
PASWRD
is displayed.
4. Press .
CNFG
is displayed.
5. Press to
USER
.
6. Press .
000000
is displayed.
7. To edit the password, use the following method; or with the 480 PLUS , use the keypad. See Section 1.7 on
page 4
• Press or to select the digit.
• Press or to increment or decrement the value.
• Press when the value is correct.
8. Press to return to
PASWRD
.
9. Press to
CONFIG
.
10. Press to return to weighing mode.
When entering a user function, the operator will now be required to enter the password.
Enter 999999 to reset password, this will also reset the configuration back to default values.
MENU
TARE
TARE
MENU
TARE
Important