Rice Lake Legend 480-2A, Technical Manual

Page: 36 / 85

User Menu Setup 29
3.1.4 USB Menu
Figure 3-5. USB Menu Layout
Table 3-5. USB Menu
SERVER/CLIENT Submenu
TRIGER Selects the operation of the port.
DEMAND Allows operation of EDP commands and will print.
COMAND Allows operation of EDP commands only, does not print.
STRLFT Stream legal for trade scale data – data is transmitted at the configured display update
rate. Will also accept EDP commands and print.
STRIND Stream industrial scale data – data is transmitted up to the configured A/D sample rate.
Will also accept EDP commands and print.
TIMOUT 0
0-65535
Timeout – inactivity disconnect timeout. A connection (either client or server) is closed if
there is no activity before the timeout expires. Time is in seconds. A timeout value of 0
disables the inactivity disconnect.
TERMIN CR/LF
CR
Termination. Selects the termination character(s) for data sent from the port.
SFMT STR1-5 Stream format – specifies the stream format used for streaming output of scale data
(TRIGER=STRLFT or STRIND). See Section 9.3 on page 62.
PORT 10001
1-65535
The TCP port number of the 480 server.
Server level only .
RMOTIP 0.0.0.0 Remote Host IP address – IP address of the Remote Host (Server) the 480 Client will
connect to.
Client level only.
RMPORT 1
1-65535
Remote Host TCP Port number – The TCP Port of the Remote Host (Server) the 480 Client
will connect to
Client level only.
EOLDLY 0
0-255
Port end-of-line delay – specifies (in 0.1 second intervals) the delay between transmitted
lines of data.
ECHO OFF
ON
Specifies whether characters received by the port are echoed back to the sending unit.
Parameter Choices Description
DEVICE HOSTPC The port is assigned to a HOSTPC, the protocol is a demand type similar to serial
communications demand mode, meaning that the port supports EDP commands and Printing.
DRIVE The port is assigned to a flash drive, the data is written in a FAT32 system, no special driver is
required.
Use the USBMEM Load and Save functions, found in the Configuration Menu (Section 3.2.1 on
page 33), to load configuration data to or from a flash drive.
PRINTR When set to PRINTR mode, the USB port can be connected to a USB printer using an
appropriate USB cable. See Section 9.8 on page 66.
TRIGER COMAND Allows operation of EDP commands only. Does not print.
DEMAND Allows operation of EDP commands and prints.
Parameter Choices Description
Table 3-4. Ethernet Menu Parameters (Continued)
ETHNET USB PFRMAT
... ...
TRIGER DEVICE
PRINTR
HOSTPC
DRIVE DEMAND
COMAND
MENU CONFIG FORMAT CALIBR PROGRM DIG IN ALGOUT PASWRD USBMEM TEST