Rice Lake Legend 480-2A, Technical Manual

Page: 51 / 85

44 480 Legend Series
3.2.10 Test Menu
Access to this menu requires the configuration password if it has been enabled.
Figure 3-18. Test Menu
Digital output relay test.
HI = Active = ON
LO = Inactive = OFF
3.2.11 User Menu Setup
See Section 3.1 on page 22.
Parameter Choices Description
ADTEST Displays raw A/D counts.
NWGMNT TOTAL The number of weighments that exceed value set in WGMNST.
OVECAP The number of weighments that exceed the capacity of the scale as set in the config and
format menus. See Table 3-10 and Table 3-12.
WGMNST 0 – 999999 Weighment Threshold – Sets the weight threshold over which WGMNST/Over value will be
counted.
DIGIN 1 – 4
VIEW
Access to display status. Allows selection of each Digital Input to display its current state, HI
or LO.
If the setting cannot viewed, that option is not installed.
DIGOUT 1 – 8
HI
LO
Access to each of the Digital Output and to manually set them individually to HI or LO. HI is
active.
If the setting cannot viewed, that option is not installed.
ALGOUT 0
25%
50%
100% Allows analog output to be manually set to certain output values for calibration and test of
external equipment
The analog output must not be in an error state as that will override these
settings. When the display division has a decimal, the test outputs will be
offset by the decimal place.
If the setting cannot viewed, that option is not installed.
DEFLT Resets all parameters to factory defaults. At DEFLT, press Gross/Net, indicator will display
SAVING and cycle power.
Table 3-19. Test Menu Parameters
Note
CONFIG FORMAT CALIBR PROGRM DIG IN ALGOUT PASWRD USBMEM MENU TEST
DEFLT ALGOUT
0
25%
50%
100%
DIGIN
1-4
VIEW
DIGOUT
1-4
HI
LO
WGMNST
999999
NWGMNT
TOTAL
OVERCAP
ADTEST
Raw A/D
Counts
Note
Note
Note
Note