REFUdrive 500 RD51
Mechanically installation
2-5
DOK-RD500*-RD51*******-IB01-EN-P
2.3
Mounting liquid-cooled converters, sizes G and H with
integrated heat exchanger
The converters, sizes G and H consist of the line filter, converter and heat
exchanger. The drive converter and heat exchanger are mounted on a
common mounting plate and connected up. For weight reasons, the line
filter has its own mounting panel.
•
The units must be mounted vertically on a flat mounting surface.
•
A minimum of 200 mm clearance must be maintained above the units
to ensure that the warm air discharge is not restricted.
•
For cabinet mounting, the cooling airflow requirements of the mounted
units (refer to the Technical Data, Section 1) must be calculated and
the cabinet cooling appropriately dimensioned.
•
The required mounting bolts are specified in the drilling templates of
the dimension drawings.
•
To mount the equipment using a crane or hoisting device, two devices
are supplied with the equipment. These are introduced at both sides at
the top of the mounting panel, and secured using a screw (refer to the
dimension drawings).
•
First mount the line filter and above it the mounting panel with
converter and heat exchanger. The two mounting panels must be
mounted directly underneath one another without any intermediate
clearance, as shown in the dimension drawing to ensure correct
cooling air routing. The busbars to connect the line filter and drive
converter are supplied.
Dimension drawing with integrated heat exchanger, size G
480 (18.9)
330 (13)
360 (14.2)
380 (15)
520 (20.5)*
390 (15.3)
850 (33.5)
1570 (61.8)
215 (8.5)
Warm discharged air
Cooling air
Cooling air
12 (0.5)
200 (7.9)
400 (15.7)
420 (16.5)
1120 (44.1)
3 x M8
5 x M8
2 x M8
Mounting de
vices with lugs
on
ready
alarm
Esc
Start
Mon
Stop
Prog
Enter
Drilling template
Side view
Front view
* The heat exchanger is 520 mm (20.5 inch) for a typical motor output of 200 kW.
Dimension in mm (inch)
Abb. 2-5: Dimension drawing converter size class G
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
