INSTALLATION INSTRUCTIONS
SeaBat 7125 SV2 Operator‟s Manual
Page 156
July 25, 2011
Version 3
C.3.4 Monitor Connections
The monitor connections
21
to the transceiver MUST be done as described in
and
. Connections are achieved using DVI-I or display port connectors. Monitors can
be cloned from within Windows®, although it is possible to clone a display port output by
first converting to DVI-D and then using a DVI-D splitter (see
section C.3.6 below
).
Table 7: DVI and Analog Monitor Connections
Connections to DVI and analog monitor:
One monitor: Use port 1.
Two monitors: Use ports 1 and 2.
Note!
For analog monitors, first add a DVI to analog adaptor
to the DVI-I connector.
DVI Ports
22
Table 8: Display Port Connections
Connections to display port monitor:
One monitor: Use port 1.
Two monitors: Use ports 1 and 2.
Three monitors: Use ports 1, 2, and 3.
Four monitors: Use all 4 ports.
Note!
The display ports cannot be converted to analog
monitors
; however, adaptors are supplied to convert to DVI-D
signals. (Note that DVI-D and DVI-I connectors are slightly different.)
Display Ports
CAUTION
When removing the display port cable
from the transceiver, press the button
(at the arrow) on the connector to
disconnect.
Do
not
pull directly on the cord, as this
will damage both cable and transceiver.
21
The DVI and display ports can be combined to maximum two monitors per video card.
22
The ports are numbered according to the numbers in the Windows® Display Properties dialog.
Summary of Contents for SeaBat 7125 SV2
Page 2: ...This page intentionally left blank...
Page 211: ......
