INSTALLATION INSTRUCTIONS
SeaBat 7125 SV2 Operator‟s Manual
Page 150
July 25, 2011
Version 3
C.2 Installation Checklist
NOTE
This checklist only covers the most basic, standard system installation. Depending on
the system configuration or specific customer requirements, this list may or may not
apply.
Follow these basic steps to install and configure your new SeaBat sonar system:
Install the dry-end components:
o
Transceiver
o
Monitor, keyboard, mouse
Install the wet-end components:
o
Receiver unit
o
Projector unit
Install and connect cables:
o
Transceiver to receiver cable
o
Transceiver to projector cable
o
Auxiliary sensor cables
o
Monitor, keyboard, and mouse connections
o
Transceiver power cable
Power up the system
Test the system
For information on configuration of the system (including I/O module configuration,
remote operation, and folder management), see
section 4 System Configuration
CAUTION
Before turning the system on, make sure that there is no significant difference between
the temperatures of the equipment and environment in order to prevent condensation.
Summary of Contents for SeaBat 7125 SV2
Page 2: ...This page intentionally left blank...
Page 211: ......
