Reson SeaBat 7125 SV2, Operator'S Manual

Page: 156 / 212

TROUBLESHOOTING
SeaBat 7125 SV2 Operator‟s Manual
Page 140 July 25, 2011
Version 3
Message Description Action Alarm Type
Failed to set up DMA Card 0, ERROR = One or more of the processing cards
has failed to initialize or is non-
functional within the transceiver. Reboot transceiver and try again. PCI Card
Failed to set up DMA Card 1 The software could not access the
processing card device. Check ADMXRC drivers. General System
Startup
Failed to unregister external trigger, ERROR
= The pulse is not being detected. Time
stamping will be done using system
time only. 1 millisecond accuracy not
possible. Check input signal cabling. Input Signal
(Timing and
Triggers)
FATAL ERROR: PPS Timestamp error
Check 1 PPS input The pulse is not being detected. Time
stamping will be done using system
time only. 1 millisecond accuracy not
possible. Check input signal cabling. Input Signal
(Timing and
Triggers)
FATAL: DMA Read size limitation reached. A general error occurred while
transferring data to the software. Reboot the system. Data Reading
FIRMWARE does not support External
Trigger. Pinging is OFF The pulse is not being detected. Time
stamping will be done using system
time only. 1 millisecond accuracy not
possible. Check input signal cabling. Input Signal
(Timing and
Triggers)
Inbound memory initialization failed. PC resources are inadequate. Check RAM or virtual memory
resources General System
Startup
Incorrect ADMXRC board found, card_1 One or more of the processing cards
has failed to initialize or is non-
functional within the transceiver. Reboot transceiver and try again. PCI Card
Internal 7k Center error One or more startup conditions have
failed. Check previous alarms or warnings and
verify software installation. General System
Startup
Internal error, 7kCenter NOT fully
operational. One or more startup conditions have
failed. Check previous alarms or warnings and
verify software installation. General System
Startup