Reson SeaBat 7125 SV2, Operator'S Manual

Page: 22 / 212

SAFETY PRECAUTIONS
SeaBat 7125 SV2 Operator‟s Manual
Page 6 July 25, 2011
Version 3
2 SAFETY PRECAUTIONS
WARNING!
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
RESON assumes no liability if this product is operated in an unsafe manner.
2.1 Operator Safety
The SeaBat™ system should be handled with attention to operator safety as well as
protection of the hardware components. General precautions include:
DO NOT connect or disconnect cables with the power on.
DO NOT attempt to open and service the projector or receiver units.
DO NOT attempt to open and service the transceiver without specific
instructions from RESON.
DO NOT operate the system while divers are in the water and closer than two
meters from the projector and receiver units. High-powered ultrasonic energy
can be hazardous to human physiology.
For safety reasons the SeaBat™ must be connected to protective earth. The protective
earth pin in the mains appliance inlet is the protective conductor terminal of SeaBat™.
WARNING!
This icon on any of the SeaBat components implies hazardous voltage on
output connection.
2.2 Equipment Safety
Each SeaBat™ component is sufficiently robust for shipboard storage while in its own
transit case or shipping box, which include handles and tie-down rings. Use appropriate
discretion in lifting these components, as the cases may be awkward and heavy.
2.2.1 Safe Handling
To ensure safe handling of the equipment:
Inspect each transit case or shipping box for physical damage prior to
opening, and each component for physical damage before installation.
Use original shipping boxes to provide adequate packaging and shock
absorption when shipping or storing the equipment.