Regency Grandview G600C, Owners & Installation Manual

Page: 62 / 104

62
|
Grandview
®
G600C Gas Fireplace
installation
Conversion from NG to LP for G600C Using SIT 885 PROFLAME Gas Valve
LP CONVERSION G600C
1
09.21.20
920-326
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !
1. Shut off the gas and electrical supply.
2. Remove the safety screen.
3. Remove the glass door.
4. Remove the logs, glass, and any other
media.
5. Remove the two log supports (4 screws)
and the grate assembly (2 screws).
Each Kit contains one LP Conversion Kit
Conversion Kit #776-977 contains:
Qty. Part # Description
1 904-977 Burner Orifice #55
1 904-529 5/32" Allen Key
1 918-590 Decal "Converted
to LPG"
1 908-528 Red "LP" label
1 910-037 LP Injector (Pilot
Orifice)
1 920-326 Instruction Sheet
Installation of LP
Conversion Kit:
10. Re-install pilot cap and pilot retainer clip.
11. Remove burner orifice with a 3/8"
wrench. Use another wrench to hold the
elbow behind the orifice. Discard orifice.
12. Reinstall new LPG burner orifice
(stamped #55) and tighten.
7. Remove the pilot retainer clip below the
pilot cap.
9. Unscrew the pilot orifice with the Allen
key. Replace it with the LPG pilot orifice
provided in the kit.
Pilot retainer clip
8. Pull off the pilot cap to expose the pilot
orifice.
13. Turn control knob to the "OFF" position.
Locate the "Hi/Lo" knob on the gas valve.
See diagram below.
Diagram 2: Slide burner assembly to the
right, then remove.
Diagram 1: Remove 6 screws.
6. Remove three screws, then remove the
burner assembly.
Fig. 1
15) Insert a 5/32” or 4mm
Allen wrench into the
hexagonal key-way
of the screw (Fig. 2).
Rotate it counter-
clockwise until it is
free and extract it.
Fig.2
14) Remove the black
protection cap from
the Hi-Lo knob
(Fig.1).
Installer Notice:
These instructions must
remain with the appliance.