NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
Edition: 003
121
10000001052
4.4.7
Lost position value in Course Control mode
The Course Control mode is executed for at least 2 minutes and the top bar
(yellowish orange) displays Dead Reckoning no Position during this time.
If no valid position is available after 2 minutes, the Course Control mode is stopped
and a switchover to Heading Control mode is performed (an appropriate message
will be displayed at the top bar).
If a valid position is available, but a position jump is detected, a switchover to
Heading Control mode is performed to prevent an unwanted rudder movement.
If a valid position is available without a position jump, the Course Control
mode continues, however, all messages (warnings) must be acknowledged.
4.5 Track Control
(see also section 1.4.5)
The Track Control mode can be started from Heading Control mode only.
All necessary data for a Track Control are generated from a connected track
planning system.
Data for the control function of the Autopilot can be adjusted.
4.5.1
Track Control mode with RAYTHEON Anschütz ECDIS
The Track Control mode is started by a track planning system (ECDIS,
Raytheon Anschütz).
Track Control mode is active.
The mode is displayed at the top right corner of the display
(Track Ctrl.).
