NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
10000001052
68
Edition: 003
Table 9
Softkeys for Acceleration Monitor Display
Function
Figure 33/1
Indication of max. speed (as calculated by the settings of
acceleration limit, see next display Setup Accel.Limit).
Figure 33/2
Indication of max. RoT (as limited by the settings of
acceleration limit, see next display Setup Accel.Limit).
Figure 33/3
Indication of min. Radius (as calculated by the settings of
acceleration limit, see next display Setup Accel.Limit).
Figure 33/4
Indication of actual speed.
Figure 33/5
Check box of currently selected RoT- limit adjusted on Main
Page. Check box is active if RoT- limit is activated. (see initial
display Figure 22).
Figure 33/6
Check box of currently selected RAD- limit (Radius) adjusted
on Main Page. Check box is active if RAD- limit is activated.
(see initial display Figure 22).
Figure 33/7
Indication of actual acceleration limit.
Figure 33/8
Information on heading source and actual heading value.
Figure 33/9
Set heading value.
For Course Control this display is designated as Presel.COG
(Preselected Course Over Ground) after turning the rotary
knob, Set COG after releasing the knob (in increments of 1
degree or 1/10 degree - depends on selected resolution).
For Track Control this display is designated as Track Course.
For Heading Control this display is designated as Set Heading.
Figure 33/10 Touch- icon, toggles resolution for the respective value.
Figure 33/11 Numerical display for the ruder angle in degrees, the arrows
next to this display show the direction of the rudder angle.
Figure 33/12 Softkey for switching to Setup Accel. Limit display.
Figure 33/13 Softkey for switching to the first display (main page).
Figure 33/14 Softkeys for changing the selected acceleration limit
parameters. Changes must be acknowledged with SET (a
small icon is displayed after a change has been made see also
Figure 34).
Figure 33/15 Softkey for switching back to the previous display, without a
transfer of changed values.
Figure 33/16 Softkey for adjusting the threshold (in percent of adjusted
acceleration limit). An overshoot of this threshold leads to an
acoustic alarm at the Autopilot (only if the softkey Warning is
set to on).
Value range: 50% to 100%/ (in increments of 5%).
