R&S 1311.6010K22, User Manual

Page: 1304 / 1611

Command reference
R&S
®
ZNB/ZNBT
1304 User Manual 1173.9163.02 ─ 62
<Unused> Ignored parameter (for compatibility with R&S ZVR analyzers).
Should be set to the default value 0.
<MeasBandwidth> IF bandwidth in the segment. See
[SENSe<Ch>:
]SEGMent<Seg>:BWIDth[:RESolution]
.
Default unit: Hz
<LO> POSitive | NEGative | AUTO
Position of the local oscillator frequency LO relative to the RF
frequency. In remote control this parameter must be set when a
sweep segment is created.
See
[SENSe<Ch>:]FREQuency:SBANd
.
<Selectivity> NORMal | MEDium | HIGH
Selectivity of the IF filter. See
[SENSe<Ch>:]SEGMent<Seg>:
BWIDth[:RESolution]:SELect
.
<Mode> AUTO
Ignored.
<FreqSweepMode> STEPped | ANALog
"Stepped" mode (=
STEPped
, default) or swept mode
(=
ANALog
). See Chapter 4.1.4.5, "Stepped vs. swept mode" ,
on page 97.
Example: SEGM:ADD
Create a new sweep segment no. 1 in channel no. 1 using
default settings.
SEGM:DEF?
Query the channel settings for the new segment. A possible
response is
1000000000,2000000000,51,-300,0.0044625,0,
10000,AUTO,NORM,AUTO,STEP
.
Manual operation: See "Optional Columns" on page 435
[SENSe<Ch>:]SEGMent<Seg>:DEFine:SELect <TimeRef>
Defines whether the sweep time of a new segment, i.e. numeric parameter no. 5 of the
command
[SENSe<Ch>:]SEGMent<Seg>:DEFine
, is entered as a segment sweep
time ("Segment Time") or as a measurement delay ("Meas Delay").
Suffix:
<Ch>
.
Channel number
<Seg> Sweep segment number
Parameters:
<TimeRef> SWTime | DWELl
SWTime - use segment sweep time.
DWELl - use measurement delay.
SCPI command reference