R&S 1311.6010K22, User Manual

Page: 773 / 1611

GUI reference
R&S
®
ZNB/ZNBT
773 User Manual 1173.9163.02 ─ 62
The upper part of the page allows you to define the checks, which can then be run with
the "Execute" button. The results are displayed in the "Log" area.
Figure 5-90: Log area
Power check definition
For each physical VNA port, you can decide whether to perform a power check
("Active"), whether to use default or custom settings ("Default Settings"), and whether
you want to ask the firmware to "Prompt before every port check".
Active
Defines whether a power test shall be executed for the related port.
Default Settings
Defines whether default or custom power and limit line settings shall be used for the
power test of the related port.
The checkbox is only enabled, if this port is set to Active . If you uncheck it, a tap/click
on the respective Custom Settings cell allows you to customize the port power test.
Custom Settings
If Default Settings is unchecked, a click/tap on the respective "Custom Settings" field
opens the "Define Limit Lines and Power Level" dialog. This dialog allows you to set
the source power for the test of the respective port, and to define port-specific
limit
lines for the test.
Setup softtool